Did someone already use DMC PARK for Park transformation with C2000 concerto ?

1 次查看（过去 30 天）
Antoine Bostem
Antoine Bostem 2018-6-8
评论： Antoine Bostem 2018-6-15
Hello, I try to use Park bloc in the concerto support package.
The block says that "All inputs and outputs are signed 32-bit fixed-point numbers with Q value between 1 and 29." But even when I change the data type it don't work...
Did someone already use that block ?
Regards,
Antoine

请先登录，再回答此问题。

回答（1 个）

Antonin
Antonin 2018-6-15
Bonjour Antoine,
I recommend the following example which uses most DMC blocks.
Permanent Magnet Synchronous Motor Field-Oriented Control
There are 2 versions for Concerto (one for F28M35x and one for F28M36x).
These examples are spinning motors with the DRV8312 Motor Control kit.
You just need an F28M35x ControlCard or an F28M36x ControlCard with this adaptor.
The Park Transform is located here:
  • 'c28M35xpmsmfoc_ert/FOC Alogrithm/Torque Control Algorithm/Generating Space Vectors/Generating Raw Space Vectors/Park Transformation'
or here:
  • 'c28M36xpmsmfoc_ert/FOC Alogrithm/Torque Control Algorithm/Generating Space Vectors/Generating Raw Space Vectors/Park Transformation'
I hope it helps,
Bonne chance,
Antonin.
  1 个评论
Antoine Bostem
Antoine Bostem 2018-6-15
Hello Antonin,
I can't run the example beacause I don't have the fixed-point designer toolbox. Is that linked to my problem ? Moreover, when I click on the block "Park" I only have the general description of the block, no parameters.
Merci ;)
Antoine

请先登录，再进行评论。

社区

更多回答在  Power Electronics Control

类别

在 Help Center 和 File Exchange 中查找有关 Texas Instruments C2000 F28M3x Concerto Processors 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by