Realising a torque rod getting a PWM current signal and controlled with PID Controller

2 次查看（过去 30 天）
Adarsh Agrawal
Adarsh Agrawal 2018-6-22
I am trying to develop a 3 axis magnetorquer on simulink. I wish to have a 3 axis control by giving desired RPY(Roll, Pitch and Yaw) values. This will be done by using a PID control block followed by a PWM block. But I am unclear as to how to integrate them.
Also it is unclear as to how to make a physical model of the orthogonal rods in simulink, so that when I give currents, the entire configuration rotates accordingly.

请先登录，再回答此问题。

回答（0 个）

社区

更多回答在  Power Electronics Control

类别

在 Help Center 和 File Exchange 中查找有关 PID Controller Tuning 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by