Can any one help me to set an adaptive threshold using matlab code?

Question

kasimala venkatanagaraju 2018-8-2

0
链接

此问题的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/413263-can-any-one-help-me-to-set-an-adaptive-threshold-using-matlab-code

编辑： Sean de Wolski 2018-8-2

Actually, I need to discriminate fault from power swing, voltage instability and load encroachment with the help of threshold setting. All the conventional threshold settings are considered based on the measured impedance, decaying dc component in the input signal etc. But, I need an adaptive threshold setting which means the system automatically set the threshold based on the type of event.

0 个评论
显示 -2更早的评论隐藏 -2更早的评论

请先登录，再进行评论。

请先登录，再回答此问题。

Answer 1

Sean de Wolski 2018-8-2

0
链接

此回答的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/413263-can-any-one-help-me-to-set-an-adaptive-threshold-using-matlab-code#answer_331338

Perhaps look at ischange or islocalmax/findpeaks.

2 个评论
显示无隐藏无

kasimala venkatanagaraju 2018-8-2

Thank you so much for your kind suggestion sir. In each and every event having different peaks like fault during power swing having 10 peaks, fault during voltage instability is 5 peaks. How can we set the threshold? if all the events having the same number of peaks then it is ok but here it was different