Hello all,
I am trying to gather data from a rotary encoder with an Arduino Uno connected to MATLAB. The encoder channels are connected to the D2 and D3 pins of the Arduino, and I use the following code to plot a short time hitory of the rpm:
a1 = arduino('COM4', 'uno', 'libraries', 'rotaryencoder');
encoder = rotaryEncoder(a1, 'D2', 'D3', 500);
rpm = nan(1, 50);
h = figure(1);
while true
rpm = [rpm(2:end), readSpeed(encoder)];
plot(rpm);
grid('on');
grid('minor');
xlim([1, length(rpm)]);
ylabel('rpm');
drawnow;
if ~ishandle(h)
break
end
end
clear('a1', 'encoder', 'rpm', 'h');
When I increase the encoder speed to more than 2000 rpm, I get an error in the command window, saying
Error using ard (line 7)
The host and client connection is lost. Make sure the board is plugged in and recreate arduino and related objects.
With 500 counts per revolution, each pin is receiving around 20k counts per second, which should be well in the limitations of the Arduino board. Is there a maximum limit to the rpm that can be read with the rotaryEncoder?
