Flash.out.file generated by simulink

2018 8 29
2 个回答
回答已采纳
更新时间：2018 9 6
5 次查看（30 天）

0 个投票

Hi,
I m using experimenter lanchpad TMS320F28027F and I m using MATLAB/Simulink for the software. The matlab generates .out file and I can debug this .out file using CCSv8. How can I flash this .out file
Where can I generate flash based simulink code? What are settings in configuration parameters? What should be the system target file to generate flash based code?
Best regards,
Mouhanned Brahim

请先登录，再回答此问题。

 采纳的回答

Antonin
Antonin 2018-9-3

0 个投票

On the snapshot below taken from MATLAB R2018a, the "Build action" can automate the load and run part, the "Boot From Flash" enables standalone execution from flash memory. Type "targetupdater" at the MATLAB command prompt to setup the connection with CCS for the load automation. For earlier MATLAB releases, you can pretend to use CCS v5 and point to the CCS v8 installation, everything should work. </matlabcentral/answers/uploaded_files/130934/Capture.JPG>

更多回答（1 个）

Mouhanned Brahim
Mouhanned Brahim 2018-9-6

0 个投票

Hi Antonin, Thnx for your responses, Ihave another problem with the epwm blocks of the c2000 embedded coder: Wich type of signals must be connected to these blocks, because i try with a pulse generator (amplitude =1), or a constant, but there is no pwm output at the corresponding pin of the target (F28027F lanchpad). There is a specific configuration of the epwm block? Thanks Mouhanned

类别

在 帮助中心 和 File Exchange 中查找有关 Texas Instruments C2000 Processors 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by