Step response due to input changes

4 次查看（过去 30 天）
Shaun Struwig
Shaun Struwig 2018-9-1
编辑： Akbar 2018-9-17
I would like to use the Matlab control systems library to compare an experimentally derived transfer function model for a practical system. The experimental step response is shown below:
The system takes a duty cycle percentage as input and has RPM of a motor as output. In the plot above the two jumps in the response are to an input of 10 and 20 respectively. I have obtained the transfer function experimentally and managed to plot the response to an input of 10 in Matlab as shown below:
What I would like to do is to create a similar plot in matlab to my experimental plot so I can compare how close the model approximates the realization. How can I use step() to input 10 initially and then to step to 20 after about 6 seconds.

请先登录，再回答此问题。

回答（1 个）

Akbar
Akbar 2018-9-17
编辑：Akbar 2018-9-17
Maybe try in Simulink, using the Signal builder block you can create Input as you want.

类别

在 Help Center 和 File Exchange 中查找有关 Digital Filter Analysis 的更多信息

标签

产品

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by