How can I speed up simulation of my PEAK USB CAN simulink Library on Raspberry Pi in External Mode?

1 次查看（过去 30 天）
srikanth balla
srikanth balla 2018-9-4
评论： robert youth 2020-12-24
I have implemented PEAK USB CAN simulink Library which will work on raspberry pi in External Model. The Library contains PCAN Initialization and PCAN Read simulink blocks which will work as hardware support packages. when i run the simulation on Raspberry Pi to read CAN data from PCAN Channels(PCAN_USBBUS1 to 6). There is a delay in simulation. CAN data is updating after some time. i observed 2 to 3 min delay. The simulink Library depends on PCANBASIC library which is installed on raspberry pi.
How can i speed up the simulation?

请先登录，再回答此问题。

回答（1 个）

srikanth balla
srikanth balla 2018-9-12
Answer
  3 个评论
显示 1更早的评论
srikanth balla
srikanth balla 2018-11-1
编辑：srikanth balla 2018-11-1
i have enabled Detect Overrun in model configuration parameters.
The following message is captured in log file of model
"Overrun detected: The sample time for the rate 0 is too short."
after some time of execution PCAN Library is not receiving CAN messages.
robert youth
robert youth 2020-12-24
Hi @ srikanth balla, This is such a wonderful project, good job! I wonder why no one has ever interested in using PCAN on Rpi or has been able to provide any assistance on this topic.
However I had no luck in running external mode, the progress stuck in the compilation phase. It would be super if there is any document provided.

请先登录，再进行评论。

类别

在 Help Center 和 File Exchange 中查找有关 Modeling 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by