清空筛选条件
清空筛选条件

'Make Error' when starting Simulink simulation

8 次查看（过去 30 天）
michaelborg
michaelborg 2012-6-22
回答： YAN WEI 2016-12-5
I am getting a Make Error with the following message: Making simulation target "DP_ForceRAOnew_sfun", ...
C:\Users\Michael\Dropbox\Codes\MSS\hydro\simulink\slprj\_sfprj\DP_ForceRAOnew\_self\sfun\src>call "\vsvars32.bat" '"\vsvars32.bat"' is not recognized as an internal or external command, operable program or batch file.
C:\Users\Michael\Dropbox\Codes\MSS\hydro\simulink\slprj\_sfprj\DP_ForceRAOnew\_self\sfun\src>nmake -f DP_ForceRAOnew_sfun.mak 'nmake' is not recognized as an internal or external command, operable program or batch file.
Within the simulink model I have a M function that performs a dos command to run a executable. Could this be the source of the error?
Regards

请先登录，再回答此问题。

采纳的回答

Kaustubha Govind
Kaustubha Govind 2012-6-22
Have you already installed a supported compiler (see last column on this page for the list against each version), and run "mex -setup"? It just seems like Simulink cannot locate a supported MEX compiler, which is needed to compile code generated from Stateflow charts or (Embedded) MATLAB Function blocks.
  6 个评论
显示 4更早的评论
Kaustubha Govind
Kaustubha Govind 2012-11-15
Shameer: I'm not sure what might be going on. Could you perhaps report this to MathWorks Tech Support and find out if this is a known issue? Thanks!
Shameer Parmar
Shameer Parmar 2012-11-27
Ok.. Thanks Kaustubha for your reply.. I will check with Mathwork Support team..

请先登录，再进行评论。

更多回答（1 个）

YAN WEI
YAN WEI 2016-12-5
Hello, have you solved your problem? I have met the same problem with you, do you have some solutions? Thanks

类别

在 Help Center 和 File Exchange 中查找有关 Event Functions 的更多信息

标签

产品

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by