How to turn a 3 phase line into a single line in a Simulink diagram?

64 次查看（过去 30 天）
Akash Menon
Akash Menon 2018-9-10
评论： Kim 2024-2-19
I have modelled a diesel generator on Simulink with the help of Simscape power systems and this serves as a 3 phase (A,B,C) source to a load. I have many more loads and energy storage systems to connect to this microgrid but there is always 3 lines that I have to connect. Is there any way to bundle these 3 lines into just one line to make the diagram look neater?
This is to create a single line diagram.
I tried using the BusCreator but it did not connect to my source because its not a signal that's being output by the Simscape block- it's a power source (electric current)
Many thanks!

请先登录，再回答此问题。

采纳的回答

Sambit Senapati
Sambit Senapati 2018-9-21
编辑：Sambit Senapati 2018-9-21
You need to convert the three lines coming from source to simulink signal using PS-Simulink converter block. Now, use buscreator to club these lines. In order to connect back these signal to simscape block use an Simulink-PS converter block.
  3 个评论
显示 1更早的评论
aldi julio
aldi julio 2021-8-5
I have a problem to convert single line diagram to 3 phase. Is there any way to convert it ?
Kim
Kim 2024-2-19
Hi, I also would like to know if there is a way to go from a single line 3-phase to 3 seperate lines in Simulink for measurements.

请先登录，再进行评论。

更多回答（0 个）

类别

在 Help Center 和 File Exchange 中查找有关 Simscape Electrical 的更多信息

标签

产品


版本

R2017b

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by