MATLAB Autoscaling Issue for Constant Numbers

1 次查看（过去 30 天）
Awais Raza
Awais Raza 2018-9-16
评论： Walter Roberson 2018-9-19
I have an array of very small constant numbers (0.0025). When I plot it, the autoscaled y-axis is [-1 1.5]. This 'zoomed out' scale makes the plotted line seem to be zero. I have used axis('tight') as well but it doesn't zoom in enough either.
t=[0:5]'; y=0*t + 0.0025; figure; plot(t,y);
If this is intended autoscaling behavior, it seems to be a poor design. Is there a way to change this behavior without defining my custom axis for every plot?
Note that if my data isn't constant, i.e. t=[0:5]'; y=0*t + 0.0025; y(3) = y(3) + eps; figure; plot(t,y);
The autoscaling is acceptable.

请先登录，再回答此问题。

回答（2 个）

Naman Chaturvedi
Naman Chaturvedi 2018-9-19
You can use axis and xlim and ylim
Awais Raza
Awais Raza 2018-9-19
Yes, I understand that I can use custom axis for every plot.
Is there a reason autoscaling for a constant line is not as smart as it is for a non-constant line? For instance, the only difference between the two plots in my post is that of a single point being a tiny bit different. Yet, the autoscale on figure 1 is very non-intuitive and that for figure 2 is exactly what I would need.
Thank you for your help.

类别

在 Help Center 和 File Exchange 中查找有关 Axis Labels 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by