real-time standalone mode file transfer

1 次查看（过去 30 天）
Pika
Pika 2018-9-28
回答： Pablo Romero 2018-12-20
I use matlab 2018a. The target is a mini-board with intel J9100 processor. With the standalone mode, the target starts correctly. But after I transfer the application file "*.mldatx" to target, the name of application file is modified automatically to force the extension of file name to be "*.mld", which can be executed by the real-time kernal and prompt "error unpacking application". I think it is caused by the incorrect extension of file name. How to make the real-time kernal to support long extension name?
  5 个评论
显示 3更早的评论
Pika
Pika 2018-9-28
If the extension of file name is restricted to 3 letters, I think real-time should generate application file name satisfying it. If I force the extension of file name to be 3, the real-time kernal can not run the application. I have bought a Speedgoat computer and I should try on it immediately. If there still exists this problem, I can only use Matlab 2016.
Walter Roberson
Walter Roberson 2018-9-28
Sorry, I am going by documentation here; I do not have a system to test with.

请先登录，再进行评论。

请先登录，再回答此问题。

采纳的回答

Pablo Romero
Pablo Romero 2018-12-20
This is a known bug. For more information refer to the bug report below:
https://www.mathworks.com/support/bugreports/1802354
Note that an upgrade to Speedgoat Library version 8.24.0.1 (or later) is required after installation of MATLAB R2018a Update 4.
Hope this helps.
Pablo

更多回答（0 个）

类别

在 Help Center 和 File Exchange 中查找有关 Real-Time Simulation and Testing 的更多信息

标签

产品


版本

R2018a

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by