Is there any way to connect a dashboard block with a constant block by command ?
1 次查看(过去 30 天)
显示 更早的评论
I want to connect a rotary switch block with a constant block by Matlab command. Is there any command to do that ?
1 个评论
Arun Joe Joseph
2019-9-18
Hi Abhijit,
Did you figure out the answer to this question, yet? If so, could you please share it? I would like to know the solution too.
I have asked a similar question, here:
回答(2 个)
Jesús Zambrano
2020-1-16
Hi Abhijit,
You can find the step to connect dashboards block in the link below fomr the documentation:
In there you will see that you need to work with a Simulink.HMI.ParamSourceInfo object. Here I copy the specific workflow:
Connect and Configure the Slider Block
Use a Simulink.HMI.ParamSourceInfo object and the set_param function to connect the Slider block to the Gain parameter of the Mu block. To connect a parameter, the Simulink.HMI.ParamSourceInfo needs to specify the block path for the block that corresponds to the parameter and the name of the parameter.
slider_param = Simulink.HMI.ParamSourceInfo;
slider_param.BlockPath = Simulink.BlockPath('vdp/Mu');
slider_param.ParamName = 'Gain';
set_param('vdp/Slider',"Binding",slider_param)
Configure the scale for the slider for a range of 1 to 10 with a tick mark spacing of 1.
slider_limits = [1 1 10];
set_param('vdp/Slider',"Limits",slider_limits)
To remove the connection, do:
set_param('vdp/Slider',"Binding",[])
Hope it can help you.
0 个评论
Nicolas Delachaume
2020-5-26
Hello,
Have you got a solution for R2018a release because the above command line leeds to the error :
MWDashboardBlock block (mask) does not have a parameter named 'Binding'
Thanks
0 个评论
另请参阅
类别
在 Help Center 和 File Exchange 中查找有关 Dashboard 的更多信息
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!