Force update scope window when running rapid accelerator mode from command line

2018 10 4
2 个回答
回答已采纳
更新时间：2018 12 19
6 次查看（30 天）

0 个投票

As stated in Design Your Model for Effective Acceleration, Simulink does not allow the update of scope unless the rapid accelerator model is run from Simulink menu, for whatever reason. However, I am using a GUI to call the Simulink model and I wish to see real-time output using the scope, but the scopes won't update.
I wonder if there is a way to change this Simulink behaviour (this restriction really seems artificial to me). Alternatively, I wonder if there is a way to pretend (using command line code) that I am running the model from Simulink menu.

请先登录，再回答此问题。

 采纳的回答

TAB
TAB 2018-10-5
编辑：TAB 2018-10-5

1 个投票

Scope will not update with sim command, but it works with SimulationCommand (please dont ask why :P)
set_param('MyModel', 'SimulationCommand', 'start')
SimulationCommand can take one of following value:
'start' | 'stop' | 'pause' | 'continue' | 'step' | 'update' | 'WriteDataLogs' | 'SimParamDialog' | 'connect' | 'disconnect' | 'WriteExtModeParamVect' | 'AccelBuild'

3 个评论
显示 1更早的评论 隐藏 1更早的评论

Kaixiang Wang
Kaixiang Wang 2018-10-5
Really appreciate your answer!
The bad news for me is that set_param does not wait for the simulation to finish, so my subsequent data analysis code (dependent on simulation export data) is screwed :( . But thanks anyway!
TAB
TAB 2018-10-5
You can use get_param('mymodel', 'SimulationStatus') combined with while loop to wait for simulation to finish.
Kaixiang Wang
Kaixiang Wang 2018-10-5
Thanks for your prompt reply. I thought about this but I doubt this is an efficient solution (in the sense that simulation runs slower). I did a few tests and I think this would increase the simulation time by roughly two or three times.
In the end it might be just a design decision to make. The other option is for me to kindly ask the GUI user to hit the Run Simulation button...

请先登录，再进行评论。

更多回答（1 个）

Qiaoli Ji
Qiaoli Ji 2018-12-19

0 个投票

Hi, Kaixiang Wang , I have met a question about matlab compiler installation. So could you help me? Thanks
QQ:1069994175

类别

在 帮助中心 和 File Exchange 中查找有关 Configure and View Diagnostics 的更多信息

产品

版本

R2017a

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by