Force update scope window when running rapid accelerator mode from command line

Question

Kaixiang Wang 2018-10-4

0
链接

此问题的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/422150-force-update-scope-window-when-running-rapid-accelerator-mode-from-command-line

回答： Qiaoli Ji 2018-12-19

As stated in Design Your Model for Effective Acceleration, Simulink does not allow the update of scope unless the rapid accelerator model is run from Simulink menu, for whatever reason. However, I am using a GUI to call the Simulink model and I wish to see real-time output using the scope, but the scopes won't update.

I wonder if there is a way to change this Simulink behaviour (this restriction really seems artificial to me). Alternatively, I wonder if there is a way to pretend (using command line code) that I am running the model from Simulink menu.

0 个评论
显示 -2更早的评论隐藏 -2更早的评论

请先登录，再进行评论。

请先登录，再回答此问题。

Answer 1

TAB 2018-10-5

1
链接

此回答的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/422150-force-update-scope-window-when-running-rapid-accelerator-mode-from-command-line#answer_339865

编辑：TAB 2018-10-5

在 MATLAB Online 中打开

Scope will not update with sim command, but it works with SimulationCommand (please dont ask why :P)

set_param('MyModel', 'SimulationCommand', 'start')

SimulationCommand can take one of following value:

'start' | 'stop' | 'pause' | 'continue' | 'step' | 'update' | 'WriteDataLogs' | 'SimParamDialog' | 'connect' | 'disconnect' | 'WriteExtModeParamVect' | 'AccelBuild'

3 个评论
显示 1更早的评论隐藏 1更早的评论

TAB 2018-10-5

You can use get_param('mymodel', 'SimulationStatus') combined with while loop to wait for simulation to finish.

Kaixiang Wang 2018-10-5

Thanks for your prompt reply. I thought about this but I doubt this is an efficient solution (in the sense that simulation runs slower). I did a few tests and I think this would increase the simulation time by roughly two or three times.

In the end it might be just a design decision to make. The other option is for me to kindly ask the GUI user to hit the Run Simulation button...

请先登录，再进行评论。