Simulink &TI f28379d ADC configuration

Question

tommaso serni 2018-11-5

0
链接

此问题的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/428145-simulink-ti-f28379d-adc-configuration

回答： Yash 2022-7-7

Hello everyone

I would like to acquire a signal from a current sensor (ACS712) using TI f28379d & Simulink, but I can not get a stable data from the ADC even using a constant and known voltage source.

Specifically, the sensor should measure the discharge current of a battery (2.5 A) by performing readings with a frequency of 10-100 Hz.

I attach the files used for the tests: Drive

Any ideas on how to configure the parameters to make a consistent reading?

Thanks, Tommaso.

1 个评论
显示 -1更早的评论隐藏 -1更早的评论

SHAMSUL AREFEEN AL MAHMUD 2021-4-20

Hello, did you able to get any solution for this issue? I am using the similar kind of current sensor and trying to connect with F28379D ADC. I ma having problem with configuring the ADC pin. I tried to get some values in ADC using software triggering but not working at all. I was giving 2 or 3 volts supply from a dc source.

请先登录，再进行评论。

请先登录，再回答此问题。