how to create a changing variable for fsolve?

2012 7 6
1 个回答
回答已采纳
1 次查看（30 天）

0 个投票

i want fsolve to calculate the output for different uc each time (increasing uc by 0.001 each time). each output from fsolve should be sent to a simulink model seperatly. so i set a loop to do so, but i believe that at the currenty constellation (if it will work)will just calculate 1000 different values? is there a way to send out the values seperately?
if not, how can i create a parameter uc. that goes from 0 to say 1000? i tried uc=0:0.1:1000, but again, the demension doen't seem to fit.
how do i create a function that takes the next element of a vector/matrix each time the function is called?
best regards

请先登录，再回答此问题。

 采纳的回答

Walter Roberson
Walter Roberson 2012-7-6
编辑：Walter Roberson 2012-7-6

0 个投票

function Result = f(YourArray)
persistent iteration_number
if isempty(iteration_number); iteration_number = 0; end
iteration_number = iteration_number + 1;
if iteration_number > numel(YourArray);
Result = [];
iteration_number = []; %reset for next cycle
return;
end
Result = some expression in YourArray(iteration_number)
end
Please also read the documentation for fsolve() as you cannot pass in parameters the way you do. Please see the section about parameterizing the function.

5 个评论
显示 3更早的评论 隐藏 3更早的评论

Hana
Hana 2012-7-6
编辑：Hana 2012-7-6
thanks for your help! i used a for loop to describe the changes on the variable, but the old results gets overwritten everytime it starts a new loop. is there any possibilities to get updated the values from each loop? or do i automatically get the updated values when i load the results of each value into simulink? the function in simulink will be called every 0.001s.
best regards
Walter Roberson
Walter Roberson 2012-7-6
Instead of using a for loop in your MATLAB code, use a MATLAB Function Block at the Simulink level with the appropriate that takes a single input (or no input at all) and outputs a single result, controlling invocations of the block at the Simulink level, either via the Simulink equivalent of a for loop or by taking a signal as input where the signal value indicates the parameter to use for fsolve()
Hana
Hana 2012-7-6
i think i understood the method you are suggesting, but i'm having trouble realizing it. i found the function-call-generator in simulink, but i'm not sure how to call the fsolve from there, since i can't write the fsolve into the matlab function directy and coder.extrinsic only calls functions and not scripts...
Walter Roberson
Walter Roberson 2012-7-6
Write a Level 2 S function if necessary.
There is a lot about Simulink that I have not put together mentally yet, as I do not have access to it myself.
Hana
Hana 2012-7-8
thank you, i will try that. &thanks for taking time answering my questions :)

请先登录，再进行评论。

更多回答（0 个）

类别

在 帮助中心 和 File Exchange 中查找有关 Manual Performance Optimization 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by