清空筛选条件
清空筛选条件

How to transmit CAN messages only if there is a change

1 次查看（过去 30 天）
Kaveh Allahdin
Kaveh Allahdin 2018-11-16
Hi everyone,
I have multiple controller connected to my simulink model through a CAN bus.
Right now I send all the messages at each step time, like the one which controlls the controlle mode, etc,which normally do not change that much,may be once or twice throughout the simulation. But I send them anyway which apparantly cause CAN bus to be oerloaded.
I wonder how I 'll be able to send command only if there is a change in values?

请先登录，再回答此问题。

回答（0 个）

类别

在 Help Center 和 File Exchange 中查找有关 Vehicle Network Toolbox 的更多信息

标签

产品

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by