How to introduce Delay of milliseconds in Simulink model?

Question

Tushar Mahalle 2018-11-29

0
链接

此问题的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/432751-how-to-introduce-delay-of-milliseconds-in-simulink-model

评论： Tushar Mahalle 2018-11-30

I have simulink model. suppose block A gives varying output (1 & 0). I need to give output of A as input to block B. But the condition is that if output of A is 1 then it is directly applied to B whereas if output is 0 then it is applied to B after delay of few milliseconds.

How to achieve this?

0 个评论
显示 -2更早的评论隐藏 -2更早的评论

请先登录，再进行评论。

请先登录，再回答此问题。

Answer 1

Jim Riggs 2018-11-29

3
链接

此回答的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/432751-how-to-introduce-delay-of-milliseconds-in-simulink-model#answer_349636

编辑：Jim Riggs 2018-11-29

Assuming that the input signal has a value of 0 or 1, I think that this will work:

You must make the following settings inside the multiport switch:

Data Port order = Zero-based contiguous

Number of data ports = 2

You can set the delay value to whatever you want inside the delay block (even a zero delay). Note that this configuration that I am showing is for a discrete loop, so you have to make sure that the simulation time step is smaller than the delay value. For example, set the simulation timestep to 1 milisecond. Set the delay to 3 for a 3 milisecond delay.