Cannot find an ADALM-PLUTO radio.

Question

Manfred Lichtenwagner 2018-12-9

0
链接

此问题的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/434714-cannot-find-an-adalm-pluto-radio

评论： Sandy 2024-6-4

Hi,

at the end of the installation of the Support Package "Communications Toolbox Support Package for Analog Devices ADALM-Pluto Radio" I get an "Hardware Setup Error" that the Adalm-Pluto cannot be found. A view to WIndows System shows the Adalm Pluto.

I tried to unistall an install several times, but it dindn't help.

MATLAB Version: 9.3.0.713579 (R2017b)

Operating System: Microsoft Windows 10 Home Version 10.0 (Build 17134)

1 个评论
显示 -1更早的评论隐藏 -1更早的评论

Sandy 2024-6-4

Hi! I know this 6 years after the original post, but if it helps anyone, I'll just leave a comment here. I'm really new to MATLAB and ADALM-PLUTO, so I'm not sure if this would work for everyone.

So I've been having the same problem for a while, with the latest version of MATLAB(R2024a), and Windows 11. I have installed all nessassry packages that must be installed before installing the Communications toolbox for ADALM PLUTO.

I have two ports in my computer and I tried both but I still got the same Hardware setup error. Tried uninstalling and reinstalling the "Communications Toolbox Support Package for Analog Devices ADALM-Pluto Radio" multiple times also no change.

So I checked my device manager and found out that it may be some sort of driver issue? The IIO and the RNDIS has warning signs on them, and when I check their properties it says no drivers found.

When I looked it up, I found this info on the Analog devices wiki site: https://wiki.analog.com/university/tools/pluto/drivers/windows

I installed the diver package they mention and it solved the problem for me.

Windows USB drivers for PlutoSDR and M2k (Windows 32-bit / 64-bit)

Hopefully this helps :)

请先登录，再进行评论。

请先登录，再回答此问题。

Answer 1

Noam Levine 2019-1-14

0
链接

此回答的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/434714-cannot-find-an-adalm-pluto-radio#answer_356364

I'm assuming you have Commnications Toolbox installed...

If so, here are a couple of things to try:

Make sure that no other software applicaiton is talking to the Pluto (if you were using IIO Oscilloscope, make sure it's closed before launching MATLAB)

On some computers, the single USB cable connection for power and signal is not sufficient for powering the Pluto, so you get strange results. You can try running a second USB cable to the Pluto power input to see if that "wakes up" the device.