while executing External Mode MEX-file 'ext_comm': ExtTargetPktPending() call failed while checking for target pkt? in c2000 F28379D launchpad Simulink,
3 次查看(过去 30 天)
显示 更早的评论
Hi everyone,
I try to vary the frequency of the PWM signals(which use for three phase inverter) by chanching the frequency of the input sine wave.In simulink model i can get the frequency variation with changing frequency of sine wave by using knob.
But when i tried in external model in c2000 F28379D launchpad and connected signals to osciloscope,there was not any variation of pwm frequency with changing the sine wave frequency and Following eror shows,
Error occurred while executing External Mode MEX-file 'ext_comm':
ExtTargetPktPending() call failed while checking for target pkt
Component:Simulink | Category:Block diagram error
Error occurred while executing External Mode MEX-file 'ext_comm':
ExtSetTargetPkt() call failed on CLOSE.
Ensure target is still running
this is my MATHLAB Simulink model,![aa.JPG](https://www.mathworks.com/matlabcentral/answers/uploaded_files/198774/aa.jpeg)
![aa.JPG](https://www.mathworks.com/matlabcentral/answers/uploaded_files/198774/aa.jpeg)
Venkatesh Chilapur do you have any suggession for this,
Thank you in Advance,
1 个评论
SALAH alatai
2021-7-30
hello
have you find the solution ?
I would like to inquire about sine wave block in external mode to implement my model in hardware side, is there any setting that must I do ?
回答(1 个)
另请参阅
类别
在 Help Center 和 File Exchange 中查找有关 C2000 Microcontroller Blockset 的更多信息
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!