How to use a variant sink depending on its input

2 次查看（过去 30 天）

Bicheng Guo 2018-12-13

0
链接

此问题的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/435537-how-to-use-a-variant-sink-depending-on-its-input

编辑： Bicheng Guo 2018-12-15

I have a s-function and it has 6 outputs, the next step is to check is there a negtive in 6 outputs. If there is one negtive, the simulation should be stop. If there is not, the 6 outputs should be passed to next s-function to continue simulating. In this case, I choose a variant sink, one of the output connects to stop block and another connects to next s-function to continue simulating. The thing is how can I use variant sink depending on its input rather than a pre-defined varable.

The pic shows how I use the variant sink, but it has an error saying that both the h and y (two of the outputs of s-funtion) are not defined.

Thank you very much！

0 个评论
显示 -2更早的评论隐藏 -2更早的评论

请先登录，再进行评论。

请先登录，再回答此问题。

采纳的回答

Fangjun Jiang 2018-12-13

0
链接

此回答的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/435537-how-to-use-a-variant-sink-depending-on-its-input#answer_352176

I think the "Variant Sink" block is un-necessary. If you want to stop the simulation when any of the output goes nagative, then you need to feed (or with some pre-process first) the output to the Stop block all the time. So the Stop block is constantly checking the value and stop the simulation when the condition is met. At the same time, also feed the output to the next s-function.

6 个评论
显示 4更早的评论隐藏 4更早的评论

Bicheng Guo 2018-12-14

编辑：Bicheng Guo 2018-12-14

Here is the whole logic, the turbine`s 6 outputs containing a negtive will lead to the next controller a complex. I have tried a check for conplex at controller, but it will leads to turibine a complex too. So I choose a variant to active only one route, either to pass variables or stop.

Still many thanks

Bicheng Guo 2018-12-14

编辑：Bicheng Guo 2018-12-15

Hi, I have solve this problem in Matlab rather than Simulink.

I use an ode45 to solve the turbine and control derivates, and ode45 has a Option. I can define an event in this option. When a complex event occurs, the ode45 can be stopped immediately。

Thank you very much for answering my problems!

请先登录，再进行评论。