Slow data reading using fscanf on serial over usb

Question

Tillmann Spellauge 2019-1-5

0
链接

此问题的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/438425-slow-data-reading-using-fscanf-on-serial-over-usb

评论： Tillmann Spellauge 2019-1-10

Hi everybody,

I have set up a serial connection over USB between Matlab and and an ESP8266 running a simple Arduino sketch.

The arduino sketch simply switches a LED on or off, when i sent it a 2 or 1 via serial respectively. After switching the LED it echoes back the character I send.

Using the Matlab code below, I was able to establish a working connection, however it takes Matlab slightly more than one second to read the data sent by the ESP8266.

This seems quite axcassive considering the relatively high boud rate of 460800 and the fact that i only read one byte of data. When using the Arduino Serial Monitor to do the same task i get a response almost instantly, just as expected.

Dose someone have a solution for this, or any ideas how to solve the problem?

Port = 'COM';
BaudRate = 460800;
comPort = serial(Port, 'BaudRate', BaudRate);
fopen(arduinoCom);
for ii = 1:1:5
fwrite(comPort, '1');
tic
A = fscanf(comPort,'%u',1);
toc
fwrite(comPort, '2');
tic
B = fscanf(comPort,'%u',1);
toc
end
fclose(comPort);
delete(instrfindall);
clear comPort;

0 个评论
显示 -2更早的评论隐藏 -2更早的评论

请先登录，再进行评论。

请先登录，再回答此问题。

Answer 1

Vishal Bhutani 2019-1-8

0
链接

此回答的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/438425-slow-data-reading-using-fscanf-on-serial-over-usb#answer_355470

The issue might be happening because writing data to your instrument takes a finite amount of time. When you do a read immediately after the write operation, the write operation might not have been complete so that is creating some delay.

1 个评论
显示 -1更早的评论隐藏 -1更早的评论

Tillmann Spellauge 2019-1-10

Hi Vishal,

thanks for your answer.

The problem was, that I wasn't sending the correct terminator to my arduino, resulting in the arduino running into a timeout. The problem was solved by setting the terminator correctly and using fprintf(); instead of fwrite();.

请先登录，再进行评论。