Data is missing in scope and in output tables when simulating a wind farm

1 次查看（过去 30 天）

Nils van Ohlen 2019-1-23

0
链接

此问题的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/441115-data-is-missing-in-scope-and-in-output-tables-when-simulating-a-wind-farm

评论： Nils van Ohlen 2019-1-25

For a simulation I received wind farm data of one year in 10 minute steps (>50000 data values). However, only a fraction of these are taken into account in the calculations and are shown incompletely in the scope. What can I do to show all data in the scope or to save all data into a table in the workspace?

0 个评论
显示 -2更早的评论隐藏 -2更早的评论

请先登录，再进行评论。

请先登录，再回答此问题。

采纳的回答

Arvind Sathyanarayanan 2019-1-23

1
链接

此回答的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/441115-data-is-missing-in-scope-and-in-output-tables-when-simulating-a-wind-farm#answer_357694

编辑：Arvind Sathyanarayanan 2019-1-23

Nils,

You'll have to check the Logging in the scope properties. Ensure that you're not limiting the data points. To save to workspace check the log data to workspace box

3 个评论
显示 1更早的评论隐藏 1更早的评论

Arvind Sathyanarayanan 2019-1-24

Have you tried using a fixed step solver with a time step that is 5 to 10 times greater than your the rate at which your look-up table data was generated?

Nils van Ohlen 2019-1-25