Engine cooling system (thermal fluid)
1 次查看(过去 30 天)
显示 更早的评论
In the engine cooling system, we have bypass hose as pipe(TL) so the error i am getting is the outlet pressure according my values cannot run the simulation and it is showing that at the outlet port (B) the pressure is less than th minimum valid pressure.
So how can i change the minimum pressure defined in the pipe (L) or how can i rectify this problem.
2 个评论
sai srinivasa chaitanya Dasari
2023-4-26
changing the pipe area can vary pressure try to change it if pressure is your concern
回答(1 个)
Just Us
2019-1-24
There are two possibilities to overcome this problem: Either you enlarge your fluid flow, which means that you raise the "input pressure" or you go to your fluid properties and define temperatures and densities and internal energies and so on for lower pressures than occuring at port B
另请参阅
类别
在 Help Center 和 File Exchange 中查找有关 Thermal Liquid Library 的更多信息
产品
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!