enable log signals through command line.

Question

Pika 2012-7-20

0
链接

此问题的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/44148-enable-log-signals-through-command-line

评论： Cou 2020-7-27

I have several reference models which has logging/test point signals. I use Simulink Signal Logging Selector to enable/disable these signals but I would like to do this through the command line. How do I do this? I have tried Simulink.SimulationData.ModelLoggingInfo.createFromModel. What do i do after this? I also then tried findSignal but it always comes back with an empty array.

0 个评论
显示 -2更早的评论隐藏 -2更早的评论

请先登录，再进行评论。

请先登录，再回答此问题。

Answer 1

Albert Yam 2012-7-20

0
链接

此回答的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/44148-enable-log-signals-through-command-line#answer_54164

编辑：Albert Yam 2012-7-20

在 MATLAB Online 中打开

I remember doing this before, but I can't find the code. I had to : 1) find the block 2) get the line (out of the block) 3) go back and find the source port 4) set your options there

lh=get_param(gcb,'LineHandles');
lhh=get_param(lh.Outport,'Handle');
sph =get_param(lhh,'SrcPortHandle');
set_param(sph,'DataLogging',1);   %this changed for newer versions I think
get_param(sph,'ObjectParameters') %there will be other things you will want
                                  %decimation, limit results to last XX points

Edit:I'm using Simulink 6.6.1, so things might be different now.

0 个评论
显示 -2更早的评论隐藏 -2更早的评论

请先登录，再进行评论。

Answer 2

Cou 2017-11-13

0
链接

此回答的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/44148-enable-log-signals-through-command-line#answer_290870

在 MATLAB Online 中打开

I realize this is an old thread and an answer has been accepted, however it appears at the top of google search results. I thought I'd add a method that preserves the logged signal in the Simulink model but programmatically disables logging. The code below is essentially the same as unchecking the "DataLogging" boxes in the Simulink Signal Logging Selector. Make sure logging mode is set to "Override signals." This tutorial was helpful as well: Log Data in Library Charts

mi = Simulink.SimulationData.ModelLoggingInfo.createFromModel(gcs);
for i = 1:numel(mi.Signals)
    mi.Signals(i).LoggingInfo.DataLogging = 0;
end
set_param(gcs, 'DataLoggingOverride', mi)