"Selection for Simulink" Widget in IBM Doors NG

2 次查看（过去 30 天）
allofdogs
allofdogs 2019-1-31
评论： Paul Urban 2020-6-17
Hi
I am trying to establish bidirection link using Simulink Requirements between a Simulink model and the requirement artifact in Doors NG. One I added the "Selection for Simulink" Widget, there is a link that is supposed to direct to the Simulink model but never works. I wonder if there is anything to do for setup.
I also consult with IBM and they said this widget was developed by Mathworks.
Thank you very much
Tony

请先登录，再回答此问题。

回答（1 个）

Paul Urban
Paul Urban 2019-4-23
To set up the integration wtih DOORS Next Generation follow these steps described in the help:
Configure RMI for IBM Rational DOORS Next Generation Interaction
This is a one time setup. Remember to run MATLAB as administrator when doing the rmi setup.
This help topic describes linking to DNG: Requirements Traceability with IBM Rational DOORS Next Generation
  3 个评论
显示 1更早的评论
steve steve
steve steve 2020-6-17
slrequirements is part of the Requirements Toolbox install
Paul Urban
Paul Urban 2020-6-17
That is correct that Simulink Requirements needs to be installed. If it is then you may want to contact support for assistance on the installation with DNG https://www.mathworks.com/support/contact_us.html?s_tid=sp_ban_cs

请先登录，再进行评论。

类别

在 Help Center 和 File Exchange 中查找有关 Manage Design Data 的更多信息

标签

产品

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by