Temperature Control using PID via Simulink
显示 更早的评论
I found that after i insert PID parameters in the model, the lightbulb keep on flickering due to fluatuated duty cycle. Also, i found that no improvement is done using the PID parameters . Does this means PID dont have any function at all in improving the lightbulb performance? Theorectically, PID suppose is better than using ON/OFF and Deadband as it could reduce flickering. The results obtained is opposing the theory. Whats wrong with the model build as shown in Figure below?
回答（1 个）
Ege Keskin
2019-2-3
0 个投票
You might achieve better results by directly using the PID block on simulink.
类别
在 帮助中心 和 File Exchange 中查找有关 PID Controller Tuning 的更多信息
2019-2-3
2019-2-3
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!
Translated by 
