Temperature Control using PID via Simulink
11 次查看(过去 30 天)
显示 更早的评论
I found that after i insert PID parameters in the model, the lightbulb keep on flickering due to fluatuated duty cycle. Also, i found that no improvement is done using the PID parameters . Does this means PID dont have any function at all in improving the lightbulb performance? Theorectically, PID suppose is better than using ON/OFF and Deadband as it could reduce flickering. The results obtained is opposing the theory. Whats wrong with the model build as shown in Figure below?
![](https://www.mathworks.com/matlabcentral/answers/uploaded_files/202514/image.png)
0 个评论
回答(1 个)
Ege Keskin
2019-2-3
You might achieve better results by directly using the PID block on simulink.
0 个评论
另请参阅
类别
在 Help Center 和 File Exchange 中查找有关 PID Controller Tuning 的更多信息
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!