how to solve this problem

6 次查看（过去 30 天）
minglangruye bian
回答： Sabin 2025-6-5
An error occurred while running the simulation and the simulation was terminated
For block 'PMSM_SMO_atan/SVPWM_control/Subsystem2/Multiport Switch', control port value '0' is not in between '1' and '6'. To suppress this message and use the default port, you can change the settings of 'Diagnostic for default case' to 'None'
Component: Simulink | Category: Block error
  2 个评论
Walter Roberson
Walter Roberson 2019-3-4
Either figure out why the control port was 0, or else make the change they suggest.
Sai kartheek Chavali
Sai kartheek Chavali 2019-3-4
PMSM_SMO_atan/SVPWM_control/Subsystem2/Multiport Switch
what is the model functionality?

请先登录，再进行评论。

请先登录，再回答此问题。

回答（1 个）

Sabin
Sabin 2025-6-5
Without a model is not possible to point to the root cause but the problem is, as the error points out, the control port of a multiport switch that is 0 but the parameter 'Data port order' is set to One-based contiguous (this means that the out of range condition is: the control input is less than 1 or greater than the number of data inputs.).

类别

在 Help Center 和 File Exchange 中查找有关 Electrical Block Libraries 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by