Linearization issues on asbQuadcopter model.

4 次查看（过去 30 天）
Eduardo Fuentevilla
回答： Talgat Alimbayev 2019-7-3
Hi!
I am trying to use the asbQuadcopter template to simulate a drone with different parameters than Mambo or Rolling Spider. However, I am having problems linearizing the airframe plant of this new drone. I am using the trimLinearizeOpPoint function provided in the project but does not seem to give a good result. In fact, if I apply this function for the Mambo parameters, it does not work well either. The state space representation matrices generated this way are totally different to the ones that are by default (linsys) in the model. Therefore, I am wondering how they were calculated in the first place, if the trimLinearizeOpPoint is a reliable function or if there is a better way of linearizing the Nonlinear model.
Thanks in advance.
  1 个评论
Talgat Alimbayev
Talgat Alimbayev 2019-7-2
Hi Eduardo,
were able to figure out this issue? I'm faced with a very similar task.
Thanks.

请先登录，再进行评论。

请先登录，再回答此问题。

回答（1 个）

Talgat Alimbayev
Talgat Alimbayev 2019-7-3
Hi,
I'm probably a bit late with my answer but anyway.
You can build a diagram like in the attached picture (it's basically the same diagram that they use, but now you can follow this tutorial to trim it https://www.mathworks.com/videos/trim-linearization-and-control-design-for-an-aircraft-68880.html
After that you should be able to trim it for different conditions. Don't overcontrain it, if it starts complaining about overconstraining then relax some constraints.
Keep in mind that Cdx (drag coef) is set to zero by default. I think their calculations for drag are wrong but I'm still investigating this. So, don't take my word for it.
Good luck.

类别

在 Help Center 和 File Exchange 中查找有关 Get Started with Aerospace Blockset 的更多信息

标签

产品


版本

R2018b

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by