清空筛选条件
清空筛选条件

How to interact Matlab with Arduino and Motor Shield Rev 3?

2 次查看（过去 30 天）
Martin Velasquez
Martin Velasquez 2019-3-18
Hello,
I've been trying sync up Matlab and Arduino (along with a rev 3 motor shield) in order to controlk a DC motor.
After creating an arduino object, along with the add on object.
As specified below, the problem comes when creating a dcmotor object.
Is there a way to get past this? and
Are there libraries available specifically for this shield?
Thanks for reading.
a=arduino('COM6','Uno','Libraries'{'Adafruit/MotorShieldV2','I2C','RotaryEncoder'});
mot=addon(a,'Adafruit/MotorShieldV2');
% Here is where I have trouble
dcm= dcmotor(mot,'port'); % I cannot specify a port
% What I mean is that the Rev3 motor shield does not specifiy "M1" or "M2" insead it uses "Channel A and B" so this is a problem

请先登录，再回答此问题。

回答（0 个）

社区

更多回答在  Power Electronics Control

类别

在 Help Center 和 File Exchange 中查找有关 Arduino Hardware 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by