Simulink Real-Time with RS-232 (receiving data)
4 次查看(过去 30 天)
显示 更早的评论
I would like to model a Simulink project where my data is coming from RS232 (UART to USB) to MATLAB Simulink Real-Time model.
I would like to see the data passed on through my UART on a scope.
I have used baseboard RS232 parameter group is Board setup(com1/none).
Using MATLAB function ( DC = fcn(u)) and passing the u value directly to scope.
I am getting errors while building the project("External mode open protocol connect command failed").
Please find the attachments regarding error and my simulation below.
0 个评论
采纳的回答
Akshay Khadse
2019-3-28
编辑:Stefanie Schwarz
2023-4-27
Please run the following command in the MATLAB Command Window to verify the Simulink Real Time installation for R2020a and earlier:
>> slrttest
Please refer the following documentation page for more information on this command:
Please check if your PCI settings are specified as recommended in the following MATLAB Answers page:
0 个评论
更多回答(0 个)
另请参阅
类别
在 Help Center 和 File Exchange 中查找有关 Target Computer Setup 的更多信息
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!