How to fit parameters in an m.file to a curve?

2 次查看（过去 30 天）
Felix
Felix 2012-8-7
To understand my problem it would be best if you run this m file:
https://dl.dropbox.com/u/368757/curve_fitting_problem.m
In the following I refer to the variable names in the file:
It will plot a measured_signal in blue to which I want to fit a function (modeled_signal, shown in red). This function is generated in the same file. However, it is not a simple one line equation (with which all curve fitting tutorials that I found are dealing). It is rather a convolution of two functions one of which is constant and the other contains some variables which I want to optimize.
How can I tell matlab to fit the "modeled_signal" to the "measured_signal" by changing the three variables in lines 9-11 (tmax, alpha, mag)?
Thank you very much for your help!

请先登录，再回答此问题。

采纳的回答

Seth DeLand
Seth DeLand 2012-8-7
Take a look at lsqcurvefit from the Optimization Toolbox. http://www.mathworks.com/help/toolbox/optim/ug/lsqcurvefit.html
You can write a function that takes in a vector with the parameter values and a vector with the xdata (t in your case), and then returns the values for the calculated modeled_signal. Then use lsqcurvefit to find the optimal parameters that fit your function to your ydata (measured_signal).
There's an example along these lines here: http://www.mathworks.com/products/optimization/examples.html?file=/products/demos/shipping/optim/datdemo.html
  1 个评论
Felix
Felix 2012-8-7
Thank you very much. It works now with this apporach. At first lsqcurvefit produced only complex numbers that made no sense, but this could be solved by setting reasonable boundaries for the solution.

请先登录，再进行评论。

更多回答（0 个）

类别

在 Help Center 和 File Exchange 中查找有关 Get Started with Curve Fitting Toolbox 的更多信息

标签

产品

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by