how to control dc motor by matlab gui with adafruit motorshield V1?

3 次查看（过去 30 天）

显示更早的评论

Bhavya Kishor Gatya 2019-4-6

1
链接

此问题的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/454817-how-to-control-dc-motor-by-matlab-gui-with-adafruit-motorshield-v1

评论： Madhu Govindarajan 2019-8-12

please help to control dc motor by matlab gui with arduino adafruit shield V1

1 个评论
显示 -1更早的评论隐藏 -1更早的评论

amin ya 2019-7-10

Any solution?

请先登录，再进行评论。

请先登录，再回答此问题。

回答（1 个）

Tony Lennon 2019-8-9

0
链接

此回答的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/454817-how-to-control-dc-motor-by-matlab-gui-with-adafruit-motorshield-v1#answer_386972

Please take a look at this video. https://www.mathworks.com/videos/using-matlab-and-arduino-for-motor-control-100737.html

It's not exactly the same HW setup, but close.

2 个评论
显示无隐藏无

amin ya 2019-8-10

This does not work! Motor Shield V1 requires legacy Matlab's Arduino support package and can't be installed beside new Matlab's Arduino support package.

Madhu Govindarajan 2019-8-12

Adafruit Motor Shield V1 has been discontinued for a while and hence was never supported by the official MATLAB Support package. However, if you are interested here are a set of instructions that shows how to create your own custom support along with an example at the bottom of that page - https://www.mathworks.com/help/supportpkg/arduinoio/ug/custom-arduino-add-on-device-library-and-code.html

If you end up creating an add-on, please share with community using File Exchange.

Regards,

Madhu

请先登录，再进行评论。

请先登录，再回答此问题。