When using the FFT tool from the powergui, a whole cycle is not analyzed despite indicating the number of cycles is 1.
1 次查看(过去 30 天)
显示 更早的评论
The signal being used as the input to the FFT analysis tool is a filtered inverter signal (filtered by hardware and PWM control). I expect the THD to be much less than 48.34% as this is the THD expected from an unfiltered inverter. If I increase the number of cycles to include more of my waveform, the THD increases.
Any suggestions?
![FFT error.PNG](https://www.mathworks.com/matlabcentral/answers/uploaded_files/215170/FFT%20error.png)
1 个评论
Kuluru Sudarsana Reddy
2021-5-18
I too have encountered the same issue. If anyone can help us to analyze the issue, that would be great
回答(1 个)
Santiago Alfonso Ospina Botero
2023-4-5
I beleive that your problem relies in the fundamental frequency that you have introduced (60Hz) when in reality the fundamental frec of your sinusoid is about 9.3 Hz. This would explain why the red line representing 1Cycle chops at around 0.02 s since 1/60 = 0.0167 s.
So I would recomend to change the fundamental frecuency to the actual sinusoid freaquency or increment the number of cycles to have a better representation of your signal for the FFT computation
0 个评论
另请参阅
类别
在 Help Center 和 File Exchange 中查找有关 Spectral Measurements 的更多信息
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!