Is there a switch that turns on for a specific amount of time? That does not depend on the system's time.

Question

Aggariyo Wanagiri 2019-5-15

0
链接

此问题的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/462335-is-there-a-switch-that-turns-on-for-a-specific-amount-of-time-that-does-not-depend-on-the-system-s

关闭： MATLAB Answer Bot 2021-8-20

Is there a switch in simulink that turns on for a specific amount of time then turns off?

For context, the orange signal runs for 1s and I want a switch that becomes closed when the orange signal < 0 and sends a yellow signal that runs for 0.5s.

Currently i am using a switch that is set at >= -0.00001 (when the signal goes down)

Any help is appreciated! Thank you!

1 个评论
显示 -1更早的评论隐藏 -1更早的评论

Aggariyo Wanagiri 2019-5-15

I need something like this. This is done manually with a pulse generator, but I need it to be conditioned by the orange signal.

请先登录，再回答此问题。

Answer 1

Shivam Sardana 2019-5-23

0
链接

此回答的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/462335-is-there-a-switch-that-turns-on-for-a-specific-amount-of-time-that-does-not-depend-on-the-system-s#answer_376286

An Enabled Subsystem can be used for your requirement. Whenever orange signal is less than 0, an enabler can be set to 1 and send to Enabled Subsystem which runs yellow signal for 0.5 seconds. A Switch can be used whose output can be passed to Scope.