Why I can't tune/design PID for a vehicle modelled with simscape?

Question

SAnbaran 2019-6-18

1
链接

此问题的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/467606-why-i-can-t-tune-design-pid-for-a-vehicle-modelled-with-simscape

回答： Steve Miller 2020-8-3

Hi all,

the model is a conventional car with multi-speed transmissoin. It is build using simscape and the control objective is 'reference tracking' of input drive cycle.

For more than a year, I have been trying methods and solutions offered in MATLAB documentation. But It has been fruitless so far and I can't get a good result from simulatoin.

The model and a written report of my work is attached to this inquiry, Please have a look. Thank you, in advance.

Looking forward to hearing from you.

Regards,

Sajjad

1 个评论
显示 -1更早的评论隐藏 -1更早的评论

SAnbaran 2019-10-23

I finally managed to do it.

The key is model fidelity and accuracy. Make sure your simscape model is accurate enough. Then, perform an open-loop test. use the system output figure to identify the time at which you should linearize your model; look for segments of output figure where model demonstrates linear behaviour. Lineanized it at that 't' and use it to tune PI controller.

请先登录，再进行评论。

请先登录，再回答此问题。