Field oriented control on Zynq Zedboard without the FMCMOTCON2 module.

Question

Zaeem Gauher 2019-6-21

0
链接

此问题的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/468282-field-oriented-control-on-zynq-zedboard-without-the-fmcmotcon2-module

回答： Joel Van Sickel 2020-8-18

I am trying to implement the Field oriented motor control example found here: https://www.mathworks.com/help/supportpkg/xilinxzynq7000ec/examples/field-oriented-control-of-a-permanent-magnet-synchronous-machine.html

I do not have the FMCMOTCON2 driver module that comes with the kit ( I have the Zedboard and the Dyno). Can I use another driver board such as the Enclustra FMC DR2? If so, do I need to change any parameters in the simulink model for this example?

0 个评论
显示 -2更早的评论隐藏 -2更早的评论

请先登录，再进行评论。

请先登录，再回答此问题。

Answer 1

Joel Van Sickel 2020-8-18

0
链接

此回答的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/468282-field-oriented-control-on-zynq-zedboard-without-the-fmcmotcon2-module#answer_481791

Hello Zaeem,

You can use the fundament control algorithm with any driver, assuming that driver is appropriately speced for your system. Assuming you are only changing the driving hardware, most parameters in the simulink model will not need to change. However, you will need to investigate the interface to the new driver and make sure that all signals are scaled/typed appropriately and the signals go to the correct i/o channels, as the interface is probably somewhat different.

Regards,

Joel