Can't use structs as outputs from simulink models

Question

guy lasri 2019-7-1

0
链接

此问题的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/469675-can-t-use-structs-as-outputs-from-simulink-models

回答： Githin George 2024-2-9

Hello,

After a few tries and reading in matlab forums i found out that it is not possible to use struct as output, and the other options is to insert struct in to bus.

While there is a lot of mentiones about it, there is not good example on how to do it.

I am using matlab function model which is under user-defined library, and use the following function:

function simconf  = fcn
    Interetions = 2;
    simconf.Interetions = Interetions;
end

I get this error: "Derived output was of type struct. 'Inherited type' is unsupported for this type and a defined bus object must be used instead. Click on 'simconf' and set data type for 'simconf' to be 'Bus: <object name>', where '<object name>' is the name of a bus object from the MATLAB workspace."

1 个评论
显示 -1更早的评论隐藏 -1更早的评论

VIGNESH BALAJI 2024-1-31

I also get this type of error. Did you find an answer ?

请先登录，再进行评论。

请先登录，再回答此问题。

Answer 1

Githin George 2024-2-9

1
链接

此回答的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/469675-can-t-use-structs-as-outputs-from-simulink-models#answer_1405726

在 MATLAB Online 中打开

Screenshot 2024-02-09 175557.png

Hello,

The error message that you have provided indicates that “struct” objects cannot be the output of a “MATLAB function” block in Simulink. You can change the output type of the function block to a “Simulink.Bus” object to correct this issue. For this task you will have to define your “Simulink.Bus” object either in base workspace or in the interactive “typeeditor”. The following code creates a “Bus” object in the workspace with the property ‘Interetions’

elems(1) = Simulink.BusElement;
elems(1).Name = 'Interetions';
TopBus = Simulink.Bus;
TopBus.Elements = elems;

Once you have created the Bus object, open the model explorer, and navigate to the “MATLAB function” block listed under your model. In the datatype section labelled “Type”, you can update the value with “Bus: TopBus” to assign the datatype correctly. Now you can use the “Bus” object without issues in the “MATLAB function” block. You can have a look at the attached screenshot for better clarity on the workflow.

The following documentation links may prove helpful in better understanding these concepts.

https://www.mathworks.com/help/simulink/slref/simulink.bus.html

https://www.mathworks.com/help/simulink/ug/create-bus-objects-programmatically.html

https://www.mathworks.com/help/simulink/ug/attach-bus-signals-to-matlab-function-blocks.html

I hope this helps.