What's Remap ePWMs for DMA access (Requires silicon revision A and above) means?

1 次查看（过去 30 天）
Xu Liu
Xu Liu 2019-7-4
评论： Xu Liu 2019-7-4
hello everyone,im doing code generation with c2000 devices,
when I make the model of 28377d to relocated 28335,im facing this choise :Remap ePWMs for DMA access (Requires silicon revision A and above)
whether i need to choise it? does there anyone have the same doubt？

请先登录，再回答此问题。

采纳的回答

Venkatesh Chilapur
Hi Xu,
You find DMA configuration under hardware Implementation pane:
Capture.JPG
  2 个评论
Xu Liu
Xu Liu 2019-7-4
it looks like you are quite good at 335,i wonder whether use DMA could be better for my project? as i know DMA seems a enrich function for data transfer and reducing cpu time, so if its so useful, whether just choise this function with my work is better?

请先登录，再进行评论。

更多回答（1 个）

Venkatesh Chilapur
Hi Xu,
From device data sheet if the silicon version is >='A' then we have the following details.
"By default, ePWM and HRPWM registers are mapped to Peripheral Frame 1 (PF1). Table 6-4 shows this
configuration. To re-map the registers to Peripheral Frame 3 (PF3) to enable DMA access, bit 0 (MAPEPWM) of
MAPCNF register (address 0x702E) must be set to 1. Table 6-5 shows the remapped configuration" of section 6.2.3.
So to use DMA with ePWM module we need to enable the re-map.
HTH,
Regards,
Venkatesh C
  1 个评论
Xu Liu
Xu Liu 2019-7-4
Hi Venkatesh
Thank you very much for your answer！
Another question is that I haven't seen dma module, is embedded coder automatically optimized for use?

请先登录，再进行评论。

类别

在 Help Center 和 File Exchange 中查找有关 Texas Instruments C2000 Processors 的更多信息

标签

产品

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by