Error in port widths or dimensions.
显示 更早的评论
The PI Controller shown in the 1st figure is used in the 2nd figure to simulate a model of PID heat exchanger controller.
ERRORS:
Error in port widths or dimensions. Output port 1 of 'Paper2/Transport Delay HE' is a one dimensional vector with 2 elements.
and
Error in port widths or dimensions. Invalid dimension has been specified for input port 1 of 'Paper2/Heat Exchanger'.
How can I remove these errors?
回答（1 个）
Fangjun Jiang
2019-7-5
0 个投票
The Outport block "Out1" in "PI Controller" is connected to a BusCreator (or Mux) block. It contains two signals. That might be a mistake. Try to connect "Out1" to the output of block "Control Valve".
2 个评论
Ananya Singh
2019-7-10
Fangjun Jiang
2019-7-10
All your signals seem to be scalar so the dimension should be 1. Update your model and start from the first place where the dimension shows 2.
类别
在 帮助中心 和 File Exchange 中查找有关 Discontinuities 的更多信息
2019-7-5
2019-7-10
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!
Translated by 
