清空筛选条件
清空筛选条件

simulation of stepper motor with microstepping

6 次查看（过去 30 天）
Kevin
Kevin 2012-8-30
回答： Sabin 2023-1-7
Hey all, I've been trying to simulate a hybrid stepper motor by using microstepping. Therefore, i took the power_steppermotor demo that comes with matlab/simulink and intended to feed it with a signal similiar to the one explained on page 8, http://www.deltron.ch/pdf/produkte/motoren/Schrittmotor_kurz_erklaert_d.pdf However, given the stepper motor demo, I get an unstable system reply just by decreasing the required step angle in the motor parameter dialog box to less than 0,45°. Is there any example for a stepper motor in micro step control? I'm looking for a couple of hours so far but I'm unable to find anything appropriate... Hope you can help me out somehow.
br
Kev

请先登录，再回答此问题。

回答（1 个）

Sabin
Sabin 2023-1-7
A good starting point is the Stepper Motor Averaged Mode example in Simscape Electrical. In this example there are three stepping methods: Full stepping, Half stepping, and Microstepping.

社区

更多回答在  Power Electronics Control

类别

在 Help Center 和 File Exchange 中查找有关 Electromechanical 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by