How to handle BusCreator programatically

Question

Matthias 2019-7-24

0
链接

此问题的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/473201-how-to-handle-buscreator-programatically

评论： Shiv Nileshkumar Matliwala 2022-11-25

Hello!

I have quite a simple question: the BusCreator has a block parameter "Require input signal names to match signals above". How can I access this setting via get_param?

Thanks a lot!

1 个评论
显示 -1更早的评论隐藏 -1更早的评论

Shiv Nileshkumar Matliwala 2022-11-25

Hello Matthias,

Can you tell me how can see the input ports and output ports of the bus creator block ??

using find_system() it should be work like

inports_bc = find_system(bus_creator,'BlockType','Input')

So, is it correct or any other way to extract this information ?

请先登录，再进行评论。

请先登录，再回答此问题。

Answer 1

Archit Dhanani 2019-7-26

0
链接

此回答的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/473201-how-to-handle-buscreator-programatically#answer_385007

Unfortunately, there is no get_param API for this parameter.

(As of R2019a ) the documentation says Note: The Require input signal names to match signals above parameter might be removed in a future release. To enforce strong data typing, consider using the Override bus signal names from inputs parameter.

1 个评论
显示 -1更早的评论隐藏 -1更早的评论

Matthias 2019-7-29

Thank you!

I know this setting; but unfortunatelly it seems that this setting does not influence the setting above :-(.

In my case I have a BusCreator with the setting "Require..." set to on with some signals on this block. When I change the signal names on the incoming lines the BusCreator does not recognize the new names even if I switch on "Override bus signal..."...?

请先登录，再进行评论。