清空筛选条件
清空筛选条件

How can I comment out an outport in Simulink model?

9 次查看（过去 30 天）
Sebastian Inderst
Sebastian Inderst 2019-7-30
回答： Marcelo Moraes 2022-1-11
I have the case where a subsystem of my model can be commented out. In that case, the outports connected to the outputs of that subsystems will give a zero when the simulation is run. In my case, I don't want anything at all, since afterwards I'm checking if a given signal exists or not, and since a 0 was given, the signal seems to exist, but it should not.
If I simply use Ctrl+Shift+X (Comment Out) on the outport, I get the warning dialog "Commenting out of the following block(s) is not supported: my_model/my_outport".
Running on Matlab 2017b.

请先登录，再回答此问题。

采纳的回答

Alex Burbee
Alex Burbee 2019-7-30
In my exerience, you can deleate the out port or simply use a termination block where it comes out.
Hope it helps

更多回答（1 个）

Marcelo Moraes
Marcelo Moraes 2022-1-11
Indeed it is not supported, but it's very frustrating.
It's like trying to add a // in the begining of a C code line and being forced to delete it before compilation.

类别

在 Help Center 和 File Exchange 中查找有关 Sources 的更多信息

标签

产品


版本

R2017b

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by