How can I comment out an outport in Simulink model?
10 次查看(过去 30 天)
显示 更早的评论
I have the case where a subsystem of my model can be commented out. In that case, the outports connected to the outputs of that subsystems will give a zero when the simulation is run. In my case, I don't want anything at all, since afterwards I'm checking if a given signal exists or not, and since a 0 was given, the signal seems to exist, but it should not.
If I simply use Ctrl+Shift+X (Comment Out) on the outport, I get the warning dialog "Commenting out of the following block(s) is not supported: my_model/my_outport".
Running on Matlab 2017b.
0 个评论
采纳的回答
Alex Burbee
2019-7-30
In my exerience, you can deleate the out port or simply use a termination block where it comes out.
Hope it helps
0 个评论
更多回答(1 个)
Marcelo Moraes
2022-1-11
Indeed it is not supported, but it's very frustrating.
It's like trying to add a // in the begining of a C code line and being forced to delete it before compilation.
0 个评论
另请参阅
类别
在 Help Center 和 File Exchange 中查找有关 Sources 的更多信息
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!