How to connect RC controller physically to computer to use Radio Control Transmitter Block in Simulink?

11 次查看（过去 30 天）
Kent Joshua Ampalaya
评论： yusuf amran 2024-10-23
How do you connect physically an RC receiver to your computer for simulation using the Radio Control Transmitter Block (from Embeded Coder Support Package for PX4 Autopilots Library) in Simulink?

请先登录，再回答此问题。

回答（1 个）

Daniel_
Daniel_ 2021-2-2
Hello Kent. If I understand well what you want to do, you need hardware - some sort of autopilot supported by Pixhawk Pilot Support Package (for example Pixhawk Cube). Then you connect the rc receiver to the autopilot, and the autopilot communicates (for example via USB) with Matlab / Simulink installed on computer. A hardware prepared in this way allows you to read and use in Matlab / Simulink the signals sent from the rc transmitter to the rc receiver.
  1 个评论
yusuf amran
yusuf amran 2024-10-23
yes we need the answer, so how to figure out the problem, i have done sync the simulink with px4 and connect the rc remote with the jmavlinka and qgroundcontrol, but rc remote did not connecting with the simulink.

请先登录，再进行评论。

类别

在 Help Center 和 File Exchange 中查找有关 PX4 Autopilots 的更多信息

标签

产品


版本

R2018b

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by