H bridge inverter output not as expected.

3 次查看（过去 30 天）
Timothy TenCate
Timothy TenCate 2019-8-2
评论： Timothy TenCate 2019-8-5
I recently created a model of an H-bridge unipolar inverter and the output of the inverter is not what I expected it to be. I have attached the file of the model and an image of the output that I am getting. The linear load that I am applying to the inverter distorts the output not as I expected. The lab results that I have for a similar project do not look like this output at all. I have tried varying the inductor and capasitor models and the time step and still receive the same results. Any help would really be appreciatted.
Tim

请先登录，再回答此问题。

采纳的回答

Shashwat Bajpai
Shashwat Bajpai 2019-8-5
I understand that you are trying to produce an amplitude modulated signal using H-bridge-inverter.
The connections in your model run the IGBT/Diode and IGBT/Diode3 in one cycle which creates a short circuit. If the expected output is an AM signal, try changing the connections from the NOT gate. This can be done by interchanging the connections of either of the pairs of IGBT/Diodes.
Hope this helps!
  2 个评论
Timothy TenCate
Timothy TenCate 2019-8-5
Thank you very much for your response. I switched the conncections around on the second pair (top and bottom) and the result was a very small voltage. I am not sure if I should have switched them the other way.
Thank you very much again for your help. I have attached an image of the output.
Tim
Timothy TenCate
Timothy TenCate 2019-8-5
I think it is working. I attached a new version that I switched the NOT gates around for each pair of IGBTs like you said and I think it is working. Thank you so much for your help!!

请先登录，再进行评论。

更多回答（0 个）

类别

在 Help Center 和 File Exchange 中查找有关 Electrical Block Libraries 的更多信息

标签

产品

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by