Thermocouple measurement in Simulink Desktop Real-time using National Instrument devices

3 次查看（过去 30 天）
Shubham Yadav
Shubham Yadav 2019-8-19
评论： Danny 2024-2-23
Hi,
I want to measure temperature using thermocouple . Currently I have NI-9211 module with chasis NI-cDaq-9174 using these I can get temperture in session based interface. Can I use these hardwares in Simulink Desktop real-time to get temperature and perform real time simulation? If not, then which NI device will be needed to take temperature reading using thermocouple.
Thanks a lot.

请先登录，再回答此问题。

采纳的回答

Roshni Garnayak
Roshni Garnayak 2019-8-22
Simulink supports NI 9211 and NI cDAQ-9174 for versions R2016b and above.
To get a list of National Instruments hardware supported by MATLAB and Simulink, refer to the following link:
https://www.mathworks.com/hardware-support/nidaqmx.html
  2 个评论
Shubham Yadav
Shubham Yadav 2019-8-23
Thanks for reply.
Yes Simulink supports NI 9211 and Ni cDAQ-9174. Can NI 9211 with NI cDAQ-9174 be used in Simulink Desktop Real time envoirenment using Real time Sync block or any other way?
Danny
Danny 2024-2-23
That is correct regarding Real time Sync block, did you manage to select K type thermocouple in the Simulink Anolog Input block in Data Acquisition Toolbox Library? I can only find mV measurement on my NI9212.

请先登录，再进行评论。

更多回答（0 个）

类别

在 Help Center 和 File Exchange 中查找有关 Target Computer Setup 的更多信息

标签

产品


版本

R2018b

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by