Buck Converter Block (Simscape Eletrical) not working properly

6 次查看（过去 30 天）
Eduardo Alves da Silva
回答： David John 2020-8-17
Hello there,
I'm doing my first projects with Simscape eletrical, and I'm having some issues with the Buck Converter Block. I'm running only the Buck converter with an constant Duty Cycle signal being used to control the Output Voltage at 50% of the input voltage (120 Volts DC), with a 100 ohms resistor as the load. I'm getting only zero volts at the output, and no current as well. When I switch to a Current source as the load, the output voltage is a 5 Volts peak to peak zero mean value.
Wasn't I supposed to get a 60 Volts DC as Output? Any help is very much appreciated.
Simple_Buck.PNG

请先登录，再回答此问题。

回答（1 个）

David John
David John 2020-8-17
You have grounded the G- node. If you are considering MOSFETs, this would correspond to the source terminal of the MOSFET. Try deleting this ground (so G- connects to REF, but not to the ground). Then you should get what you expect.

类别

在 Help Center 和 File Exchange 中查找有关 Simscape Electrical 的更多信息

标签

产品


版本

R2018a

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by