Transport delay block numerical problem

1 次查看（过去 30 天）
Alexandru Bitca
Alexandru Bitca 2019-8-30
编辑： Alexandru Bitca 2019-8-30
I have a Simulink model which contains a Transport Delay block that is being fed with a constant value when it causes the following issue:
While running, the Transport Delay block introduces an xe-16 difference between the input and output signals.
This difference is then captured by a downstream Relational Operator block which compares the input and output of the Transport Delay block.
Any ideas why this might happen?

请先登录，再回答此问题。

回答（1 个）

Osama Khallouf
Osama Khallouf 2019-8-30
I ran into a similar problem a while ago and could not figure out the reason behind. Nevertheless, I tried this and it worked.
I am assuming that the Relational Operator compares the signal you are displaying (out - in) with zero. Change that into comparing the absolute value of (out - in) to a specified value of error (1e-15 for example), so it will behave as there is no difference between the 2 signals as long as the absolute difference is less than that specified value.
Hope you find this helpful.
  1 个评论
Alexandru Bitca
Alexandru Bitca 2019-8-30
The Relational Operator block compares the input and the output of the Transport Delay block.

请先登录，再进行评论。

类别

在 Help Center 和 File Exchange 中查找有关 Sources 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by